Manualshelf

Installation Guide

ManualsBrandsReal Solutions for Real Life ManualsKitchen8.375 in. x 17.3125 in. x 20.125 in. In Cabinet Pull Out Single Soft-Close Trash Can
123
Clip
Retainer
Tab
Mounting
Straps
Sliding Members
Parts Included
A. Waste Bin (1)
B. Wire Cage (1)
C. Sliding Base Assembly (1)
D. Handle (1)
E. Cage Locking Clip (1)
F. Mounting Screws (4)
Sliding Single Soft-Close Waste Bin
Inspect all parts and read all instructions prior to beginning assembly and installation.
310402-D_0616
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
©2016 Knape & Vogt. All rights reserved. Made in USA. Knape & Vogt
®
reserves the right to change specifications without notice.
Tools Required
• Phillips head screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
BLSC9-1-20-R
BLSC10-1-35-R
SCB-9-1-20
SCB-10-1-35
SCB-12-1-50
SCB-15-1-20
Product Assemblies
1. Place sliding base assembly on cabinet floor, in desired position. Position front mounting strap
against the back edge of the cabinet face frame. (If installing in a frameless cabinet, measure
1/2" to 3/4" back from front of cabinet opening, and align sliding base assembly parallel to cabinet
opening.) Close door to make sure the assembly will not hold cabinet door open. Also, check
to see if unit will clear the door opening when fully extended. Once position is determined, fasten
in place using four mounting screws provided and a Phillips head screwdriver.
Optional Step: Mark placement of mounting holes with a pencil, remove sliding
base assembly and drill pilot holes for fastening screws. Place sliding base
assembly back into position and fasten with the provided screws.
2. Fully extend sliding members out of the cabinet. Place the slotted holes on the cage onto the tabs
on the left hand sliding member. (2A) Rest the cage on top of the clip retainers on the right hand
sliding member, but, DO NOT PUSH DOWN. Close unit so that the wire cage is completely inside of
the cabinet. Now, push down firmly on the right side of the wire cage, until it is fully seated
into the clip retainers. (2B)
3. Install cage locking clip into right hand side only by placing the tabs on the top of the clip into
the openings in the slide. Then push the top and bottom of the clip until it snaps into place. (3)
4. Clip handle onto front of cage. (4)
D
E
F
B
C
A
1
2A
4
2B
Clip Retainer
Pull Bottom
Push Top
Push Bottom
Push Top until it snaps
Step 2
Step 1
3

Summary of content (3 pages)