Installation Guide

Step 1 Install hinges per hinge installation instructions
Step 2 Lay false drawer panel face down, and position tray 1/4" below the pencil
mark indicating the top of cabinet opening. Center tray on the panel, and
make a mark in the top of the keyhole on each end of the tray. Make sure
screws are shorter than panel thickness. Remove tray and drill two pilot
holes 1/4" deep through keyhole marks. Attach screws, leaving screw
head 1/8" above the panel. Attach tray after hinges and drawer front are
installed.
Parts Included
A. Mounting Screws (10)
B. Sink Front Tray(s)
Tools Required
• Phillips Screwdriver
• Drill with 1/16" diameter
drill bit for drilling pilot holes
• Tape Measure or Ruler
• Pencil
Product Assemblies
PSF8.62SH-2
PSF11-PF-SH-2
PSF11SH-2
PSF114-PF-SH-2
PSF14SH-2
SF-11-SH1-R-SS
PSF-11-SH1-R-W
PSF-14-SH1-R-W
1/4" [6.35mm]
Sink Front Tray
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
RN-206EFS_B_0616
©2016 Knape & Vogt. All rights reserved. Made in USA. Knape & Vogt
®
reserves the right to change specifications without notice.
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com