Instructions for Use

Conversion of the Interlink Controller to Mode 1

IMPORTANT: If you damage your Interlink controller

whilst performing this modification, it will not be

covered by the manufacturer’s warranty. However, if

you follow these instructions with care, you should

encounter no issues. Just be sure to keep all removed

parts in a safe place until they are required to be re-

installed elsewhere in the controller. If, after reading

this, you feel unable to perform the modification

yourself, it can be returned to the Hobbico Service

Department for modification at no cost

You will require:

 Phillips Screwdriver PH1

 Tweezers

Place the Interlink controller face down (we’d

recommend on a cushion or similar to protect the sticks),

remove the 4x Philips head screws and carefully remove

the controller’s rear panel as shown.

Remove the connector plate

Unscrew and remove the ratchet plate as shown. Place it

to one side for later re-installation.

Carefully detach the spring as shown using the tweezers.

First unclip from the top and then the bottom. Place it to

one side for later re-installation.

PAGE 1
Conversion of the Interlink Controller to Mode 1 IMPORTANT: If you damage your Interlink controller whilst performing this modification, it will not be covered by the manufacturer’s warranty. However, if you follow these instructions with care, you should encounter no issues. Just be sure to keep all removed parts in a safe place until they are required to be reinstalled elsewhere in the controller.
PAGE 2
Conversion of the Interlink Controller to Mode 1 8. Lift up lever and remove from pivot shaft as shown. 9. Re-attach the lever on the opposite side as shown. 10. Pivot lever down as shown 11. Re-attach spring in reverse order from how it was originally removed. 12. Re-attach spring to lever, lower hook first 13. Attach other end of spring to upper hook as shown 14. Screw the ratchet plate on the opposite side as shown 15. This is how the finished modification should look.