User Manual

8
ADJUST THE SET SCREW
1. Swing leg closest to Set Screw
inward slightly.
2. Pull Angle Stop out until
it stops, then swing leg
completely out.
3. Insert 2.5mm hex key into Set
Screw, then turn clockwise to
tighten it against the bottom of
your tripod head.
The Mk2 tripods with fixed apexes come with one Set Screw that can be used
to prevent your tripod head from coming loose. For clarity, drawings do not
show the tripod head installed to the tripod. Install your tripod head, then
follow steps.
1
2
Set
Screw
Note that if you tighten the Set
Screw it will almost certainly
mar the bottom of your tripod
head. To semi-permanently
install your tripod head and
avoid any blemish marks use
one drop of threadlocker fluid
on the Stud (included with
your tripod) when you install
your head.
3