User's Manual
Table Of Contents
- General Description
- Features
- System Applications
- Block Diagram
- Pin Assignments
- Pin Descriptions
- CPU Access to Endpoint Data
- USB Request
- Get Descriptor-Device
- Get Descriptor-Device Qualifier (High Speed)
- Get Descriptor-Configuration
- Get Descriptor-String Index 0
- Get Descriptor-String Index 1
- Get Descriptor-String Index 2
- Get Descriptor-String Index 3
- Get Descriptor-String Index 4
- Get Descriptor-String Index 5
- Get Descriptor-Other Speed Configuration
- Set Address
- Set Interface 0
- Set Feature Device
- Clear Feature Device
- Set Config 0
- Set Config 1
- EEPROM (93C46 or 93C56) Contents
- USB Packet Buffering
- Functional Description
- Application Diagram
- Electrical Characteristics
- Mechanical Dimensions
- Ordering Information
RTL8187L
Datasheet
Wireless LAN Network Interface Controller 23 Track ID JATR-1076-21 Rev. 1.2
Table 28. Tx Status Descriptor
Offset# Bit# Symbol Description
0 31:28 RSVD Reserved.
Tx Rate.
These four bits indicate the current frame’s transmission rate.
Bit 27 Bit 26 Bit 25 Bit 24
1Mbps 0 0 0 0
2Mbps 0 0 0 1
5.5Mbps 0 0 1 0
11Mbps 0 0 1 1
6Mbps 0 1 0 0
9Mbps 0 1 0 1
12Mbps 0 1 1 0
18Mbps 0 1 1 1
24Mbps 1 0 0 0
36Mbps 1 0 0 1
48Mbps 1 0 1 0
54Mbps 1 0 1 1
Reserved All other combinations
0 27:24 TXRATE
0 23 RTSEN RTS Enable.
Set to 1 indicates that an RTS/CTS handshake shall be performed at the
beginning of any frame exchange sequence where the frame is of type Data or
Management, the frame has a unicast address in the Address1 field, and the
length of the frame is greater than RTSThreshold.
RTS Rate.
These four bits indicate the RTS frame’s transmission rate before transmitting the
current frame and will be ignored if the RTSEN bit is set to 0.
Bit 22 Bit 21 Bit 20 Bit 19
1Mbps 0 0 0 0
2Mbps 0 0 0 1
5.5Mbps 0 0 1 0
11Mbps 0 0 1 1
6Mbps 0 1 0 0
9Mbps 0 1 0 1
12Mbps 0 1 1 0
18Mbps 0 1 1 1
24Mbps 1 0 0 0
36Mbps 1 0 0 1
48Mbps 1 0 1 0
54Mbps 1 0 1 1
Reserved All other combinations
0 22:19 RTSRATE
0 18 CTSEN CTS Enable.
Both RTSEN and CTSEN set to 1 indicates that the CTS-to-Self protection
mechanism will be used.