User's Manual

UM0023
2015-07-21 4
After installation, connect the board to PC, and then there should be mbed Serial Port shown in
Device Manager.
3.2 J-Link/JTAG
The board is configured as CMSIS-DAP mode. To use J-Link debugger, please follow the next
procedures.
Hardware Configuration
Weld JTAG and log UART connectors to HDK board and connect with pitch 2.54mm 2x5pins
connector. It is recommended to weld the connector on the bottom side.
p.s. J-Link is supported on RTL-AMEBA_DEV_3V0