User's Guide

Brazil notice
Este equipamento deve ser conectado obrigatoriamente em tomada de rede de energia elétrica que possua
aterramento (três pinos), conforme a norma nbr abnt 5410,visando a segurança dos usuários contra choques
elétricos.
Denmark
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.
Finland
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Norway
Apparatet må tilkoples jordet stikkontakt.
Sweden
Apparaten skall anslutas till jordat uttag.
Power supply requirements
The power supplies on some products have external power switches. The voltage select switch feature on the
product permits it to operate from any line voltage between 100-127 or 200-240 volts AC. Power supplies on
those products that do not have external power switches are equipped with internal circuits that sense the
incoming voltage and automatically switch to the proper voltage.
For safety reasons, use only the AC adapter provided with the unit or an authorized replacement adapter from
HP Inc. Replacement part numbers may be found at http://www.hp.com/cgi-bin/hpsupport/index.pl.
For use in Norway
This product is also designed for an IT power system with phase-to-phase voltage 230V.
Power cord set requirements
The power cord set received with the product meets the requirements for use in the country where the
equipment was originally purchased. Use only the power cord provided with the unit or an authorized
replacement power cord from HP Inc. or an approved HP Inc. source. Replacement part numbers may be found
at http://www.hp.com/cgi-bin/hpsupport/index.pl.
Power cord sets for use in other countries must meet the requirements of the country where you use the
product. For more information on power cord set requirements, contact your authorized HP dealer, reseller, or
service provider.
WARNING! Do not use power cords from other products.
Mismatched power cords may result in a shock and re hazard.
The requirements listed below are applicable to all countries:
1. The power cord must be approved by an acceptable accredited agency responsible for evaluation in the
country where the power cord set will be installed.
2. The length of the power cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). For a power cord 2.0 m
(6.56 feet) or less, the diameter of the wire must be a minimum of 0.75 mm
2
or 18AWG. If the power
cord is longer than 2.0 m (6.56 feet), the diameter of the wire must be a minimum of 1.0 mm
2
or 16AWG.
Power supply and power cord set requirements 31