Data Sheet

What is SoftAP?
SoftAP, or software-enabled access point, allows your devkit to act as a wireless access
point/hotspot through its integrated Wi-Fi module. The devkit's SoftAP IP address is 10.1.1.1. We
will be using the devkit's SoftAP for the initial setup.
Connect to OOBE
Warning: If completing OOBE via a mobile device, be aware that data rates from your
mobile carrier may apply.
1. To get started, power on your devkit.
2. If the host computer you will be using has an active WWAN/Cellular connection, disconnect
from it before proceeding. This can sometimes cause interference to the SoftAP.
3. From your host computer, establish a Wi-Fi connection to the devkit's SoftAP. This varies by
platform (Windows/Linux/Mac).
i. SoftAP/Hotspot SSID: scz-xxxx (where xxxx = the last four digits of the devkit's Wi-Fi
MAC address)
ii. Password: santacruz (if you have already manually set your SoftAP password during
the OOBE, enter that password here)
[!NOTE] If you experience issues while trying to connect with the devkit's SoftAP please
review the known issues page. Windows may complain about the SoftAP using a less secure
standard (WPA2+TKIP cipher). This will be addressed in a future build to only allow
connections via the CCMP pairwise cipher.
4. Open a browser and go to http://10.1.1.1:4242 to access the OOBE. If you have already
flashed your device to a newer build, use http://10.1.1.1.
OOBE procedure
1. Click Next on the OOBE Welcome screen.