User's Guide

WARNING! Use of controls or adjustments or performance of procedures other than those specied herein
or in the laser product’s installation guide may result in hazardous radiation exposure. To reduce the risk of
exposure to hazardous radiation:
● Do not try to open the module enclosure. There are no user-serviceable components inside.
● Do not operate controls, make adjustments, or perform procedures to the laser device other than those
specied herein.
● Allow only HP Authorized Service technicians to repair the unit.
Power supply and power cord set requirements
Power supply class I grounding requirements
For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the
system power cord into an AC outlet that provides a ground connection. Substitute cords may not provide
adequate fault protection. Only use the power cord supplied with this product or an HP Inc. authorized
replacement.
Brazil notice
Este equipamento deve ser conectado obrigatoriamente em tomada de rede de energia elétrica que possua
aterramento (três pinos), conforme a norma nbr abnt 5410,visando a segurança dos usuários contra choques
elétricos.
Denmark
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.
Finland
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Norway
Apparatet må tilkoples jordet stikkontakt.
Sweden
Apparaten skall anslutas till jordat uttag.
Power supply requirements
The power supplies on some products have external power switches. The voltage select switch feature on the
product permits it to operate from any line voltage between 100-127 or 200-240 volts AC. Power supplies on
those products that do not have external power switches are equipped with internal circuits that sense the
incoming voltage and automatically switch to the proper voltage.
WARNING! To reduce potential safety issues, only the AC adapter provided with the computer, a
replacement AC adapter provided by HP, or an AC adapter purchased as an accessory from HP should be used
with the computer.
For use in Norway
This product is also designed for an IT power system with phase-to-phase voltage 230V.
Power supply and power cord set requirements 17