Operator's Guide

Live Interactive Holography System 3D Control Device Guide

1. Product Overview

Note

For complete instructions pertaining to the HOLOSCOPE-i system’s deployment and

operation, refer to the HOLOSCOPE-i system’s operation guide (P/N # 20-18-001).

The 3D Control Device is used to navigate through functions that control hologram interaction.

It is one of several ways of communicating with the HOLOSCOPE-i system and entering

commands and provides the interface for performing interactions with the hologram. It is

equipped with a complete set of hologram-manipulation buttons that duplicate the commands

available on the touch-screen monitor and in the hologram itself. The 3D Control Device can be

mounted on the bedside with the ability to easily remove it.

The 3D Control Device is powered by an internal Lithium Ion (Li-On) battery. The battery should

be recharged at least once a week.

The 3D Control Device communicates with a USB Dongle that is located in the main system (This

Dongle is FCCID: 2AAHQ-SMPW-RC).

Isometric View Top View

Figure 1: HOLOSCOPE-i System 3D Control Device