Operator's Guide

Live Interactive Holography System 3D Control Device Guide
15. Slice – After activating the Slice mode, you can slice into the hologram to view the internal
anatomy. In the frame that appears you may define the plane (direction) you want to slice
into, then move the cursor into the visual field and slice into the image.
16. Rotate – activate this function to rotate the hologram in any desired direction, either by
inserting your hand into the visual field and rotating the hologram with your index finger, or
via the 3D Control Device.
17. Zoom – activate this function to zoom in or out of the hologram via the joystick (push
forward to zoom in; pull back to zoom out).
4. Regulatory Information
FCC
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
6