Instruction Manual

ManualsBrandsRearviewSafety ManualsCar MultimediaRVS-splitter

Quad box brief manual

Front side of quad box

Power cable

Red: DC9-36V input positive

Black: input ground

Red (not in the black tube): DC12V output

Black(not in the black tube):ground

Brown: trigger wire of camera 1

Blue: trigger wire of camera 2

Yellow: trigger wire of camera 3

White: trigger wire of camera 4

Summary of content (5 pages)

PAGE 1
Quad box brief manual Front side of quad box Power cable Red: DC9-36V input positive Black: input ground Red (not in the black tube): DC12V output Black(not in the black tube):ground Brown: trigger wire of camera 1 Blue: trigger wire of camera 2 Yellow: trigger wire of camera 3 White: trigger wire of camera 4
PAGE 2
Video output cable This video cable must be used , otherwise the quad box can’t work normally.
PAGE 3
Keep pressing “MENU” key for 3 seconds , the quad box will exit the menu.
PAGE 4
CAMERA PRORITY: User can choose “NO PRIORITY” ( 4 trigger wires have same priority;or “CAM1” ( trigger wire for CAM1 has highest priority , when it is using , the other 3 trigger wire don’t function ) VCR OUT(assistant video output connector to connect DVR or other monitor )：User can choose QUAD/CAM1/CAM2/CAM3/CAM4/None POWER ON OUTPUT : user can choose no output /quad/CAM1/CAM2/CAM3/CAM4/Splite1-2/Splite 3-4 If choose “no output” , means the quad box will on stand by mode ( power indicate light show red)
PAGE 5
Auto sequence means the quad box will show camera1,2,3,4 on full screen by turn , the default display time for each camera is one second . There are 2 way to use the AUTO SEQUENCE function : (1)Press the “AUTO” key on the quad box ; (2) Press the key on the key board ,the screen will show quad vision ,then press again ,the screen will show camera from 1-4 by turn . “Hold time” means the camera image delay time on the screen after the trigger wire operation is over.