Specifications

Ruizhen Information Technology (Shenzhen) Co., Ltd RM-RF10TP-1278
1919
Marketing Department Contact Skill( Wang Aicheng):1381010367 Email: [e-mail]: Wang Aicheng
Location: A 1108, Xinghe WORLD A Building ,1 Yabao Road, Nankeng Community, Bantian Street, Longgang
District, Shenzhen
Integration instructions for host product manufacturers according to KDB 996369 D03
OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition
or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer have to consult
with module manufacturer for the installation method in end system.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The EUT application the FCC part 15.231 rules, No need to evaluate RF exposure.
2.7 Antennas
This radio transmitter 2AZV8RM-RF10TP-1278 has been approved by Federal Communications Commission to
operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included
in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use
with this device.
Model
Type
Peak Gain(dBi)
400-500MHz
External antenna
3.0 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following "Contains FCC ID: 2AZV8RM-RF10TP-1278".
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with limit modular approval should perform the test of radiated emission
and spurious emission according to FCC part 15C:15.231 and 15.209 requirement, only if the test result comply with
FCC part 15.231 and 15.209 requirement, then the host can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B.