User Manual

SETUP MENU OPTIONS
30
NOTE
• Dynamic Range Compression is applied to the analogue audio output and digital audio outputs
(HDMI, Coaxial and Optical) when the audio format is set to PCM.
5. SACD Mode (UBR-X110 / UBR-X200) : Select which audio layer to play for SACD (Super Audio CD).
• CD – Play the CD layer of a hybrid SACD disc
• SACD 2CH – Play the high resolution 2-channel stereo audio layer
• SACD MCH – Play the high resolution multi-channel surround audio layer
6. Speaker Setting (UBR-X200) : Select the number of audio output channels. The options are as follows :
• 2.x – This mode converts multi-channel audio to 2-channel stereo. A Dolby Pro Logic amplifier will
decode the audio signal in surround stereo.
• 3.x – This mode enables 3.1-channel decoded audio output. The number of actual output channels
depends on the disc.
• 4.x – This mode enables 4.1-channel decoded audio output. The number of actual output channels
depends on the disc.
• 5.x – This mode enables 5.1ch decoded audio output. The number of actual output channels depends
on the disc. If the source content has more channels, the surround back channels will be mixed into the
surround channels.
• 6.x – This mode enables 6.1ch decoded audio output. The number of actual output channels depends
on the disc. If the source content has more channels, the surround back channels will be mixed into the
surround channels.
• 7.x – This mode enables 7.1ch decoded audio output. The number of actual output channels depends
on the disc. For 6.1ch contents, the left and right surround back speakers will both output the same
surround back audio channel.
NOTE
• Dynamic Range Control (DRC) also affect the HDMI, coaxial, and optical outputs.
• Speaker Setting mainly applies to the multi-channel analogue audio outputs. However,
when S/PDIF Output is set to PCM in the Setup Menu, its signal becomes a down-mixed
stereo version of the multi-channel signal that is sent to the multi-channel analogue audio
outputs. As a result, the PCM signal from the coaxial and optical output is affected by the
settings in Speaker Setting.
• HDMI is unaffected by the settings in Speaker Setting, and the coaxial and optical outputs
are also unaffected by these settings when S/PDIF Output is set to Bitstream.