User Manual

Version Number: RBM1300-20210109A1
17
Note：
1) Please strictly follow the picture instructions to connect, otherwise it will not be possible to solder.
2) The flux-cored welding wire supports 0.8mm, 1.0mm.
3) The machine can install 1kg(2.2lb) welding wire reels.
4) The machine is equipped with a 1kg(2.2lb) flux cored wire, which can be directly installed and used.
5) Support welding material, carbon steel, aluminum and stainless steel cannot be welded.
6) The diameter of the welding wire, the groove of the wire feed wheel and the aperture of the contact tip must
match.
7) The pressure roller of the wire feeding structure should not be too tight or too loose, which will cause the
wire feeding to be unstable.
8) The installation of the wire feed reel should not be too loose or too tight, which will cause the welding wire of
the wire reel to spring off and the wire feeding too slow.
Possible problems
1) There is no response when turning on the power, please check the plug connection.
2) There is no response when turning on the power, please open the cover and check whether the internal
connecting wires are loose.
3) The wire feeding is unstable. Please check the wire feeding reel and the wire feeding pressure roller, and the
welding gun should not be wound. Pay attention that the diameter of the welding wire matches the wire
feeding wheel groove and contact tip.
4) No wire feeding, please confirm that the working mode is MIG state, please confirm that the welding gun is
connected well, press the gun switch or no wire feeding, please contact us.
5) During the welding process, if the time exceeds 3 minutes, over-current protection may occur. You need to
stop working for a few minutes, let the machine cool for a period of time, and automatically recover. If the air
cools for more than 10 minutes, the machine does not automatically recover, please shut down and restart.
6) If you have any questions, please contact us at [e-mail].
3、LIFT TIG mode:
REBOOT RBM1300 for thin plates with higher welding process requirements or welding with higher process
requirements, especially for stainless steel welding, you can use the LIFT TIG mode, which requires the use of pure
argon.
1、 Select “Lift TIG ” process.
、
2、 How to connect.