Owner's Manual

ASSEMBLY INSTRUCTIONS

STEP 2: SLIP SLEEVES

STEP 1: Stationary Option

Screw each FEET LEVELER (G) into the

bottom of each BOTTOM POLE (A). Turn

clockwise to screw in place.

STEP 1: Mobile Option

* For safety and stability, the lowest SHELF (D) should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (E)—this is normal.

A (4)

Screw each CASTER (F) into the bottom of

each BOTTOM POLE (A). Turn clockwise to

screw in place. Make sure the Locking Casters

are on the same side.

Use the provided caster wrench to tighten

completely. Failure to do as instructed

could result in the caster stem breaking.

F (5) G (5)

A (5) E (10)

For easiest assembly, do not connect the TOP

POLES (C), MIDDLE POLES (B), and BOTTOM

POLES (A) until instructed. Once connected, these

will be the posts for the Rack.

Note that each POLE (A+B+C) has slight horizontal

line indentations at 1” intervals. Each SLIP SLEEVE

(E) has raised horizontal lines inside designed to

lock them in place on the POLE (A+B+C).

On BOTTOM POLE (A), place 1 pair of SLIP

SLEEVES (E) at the desired level. Please make

sure the arrow faces up and that the word “TOP” is

right side up. Do this for each BOTTOM POLE (A),

and make sure that the heights are identical for

each BOTTOM POLE (A).

Slide the pair of SLIP SLEEVES (E) until you hear a

click to confirm the pair is locked onto the BOTTOM

POLE (A). DO NOT place more than one pair on

each BOTTOM POLE (A) at a time.