Installation & Assembly

Wall-Mount Folding Bench Instructions

Thank you for your order!

We are condent that you will enjoy your Wall-Mounted Teak

Bench for many years to come. An essential part of your

satisfaction is properly mounting the bench. Failure to do so

may result in injury to you or a loved one.

If you are missing any of the hardware or any of the components

appear to be damaged, please contact your dealer immediately.

Do not attempt to mount the bench until any missing hardware or

damage is corrected.

Step 5

Using a drill and a 5/32" bit, drill pilot holes in the wall being sure to stay centered

on the stud. Be sure to check that all of the pilot holes line up with the bracket

before proceeding. Make any necessary adjustments.

Step 6

Again, have someone hold the seat in place while you set the screws in place.

Use a #3 Phillips screwdriver to set the screws in part way. Double-check the

level of the bench. This is your last chance to make any minor adjustments. Once

you’re satised with the level, using your power drill tted with a #3 Phillips bit

(you may need the 6" extension bit at this point), drive the screws rmly against

the wall brackets. Do not over-tighten as this can compromise the strength of the

bracket. Hand test all of the screws to be sure that they are solidly set in place.

Step 7

Test the locking mechanism of the mounted bench, ensuring that the bench can

be raised and lowered easily.

Step 8

Load test the bench to conrm secure mounting.

CAUTION:

You must adhere to your local building codes. If you are in doubt or feel unsure

about mounting the bench yourself, contact a licensed contractor.

TIPS:

If the brackets sound like they are grinding, simply loosen each screw very

slightly (no more than a 1/4 turn at a time) while testing after each adjustment.

If you have any questions about the mounting procedure, feel free to contact

or email us.

PAGE 1
Step 5 Using a drill and a 5/32" bit, drill pilot holes in the wall being sure to stay centered on the stud. Be sure to check that all of the pilot holes line up with the bracket before proceeding. Make any necessary adjustments. Wall-Mount Folding Bench Instructions Step 6 Again, have someone hold the seat in place while you set the screws in place. Use a #3 Phillips screwdriver to set the screws in part way. Double-check the level of the bench. This is your last chance to make any minor adjustments.
PAGE 2
The tools you need are: Stud Finder, Drill, 5/32" drill bit, #3 Phillips Screwdriver, 6" #3 Phillips Bit Extension, 12" or longer Level, Tape Measure, and a Pencil. electrical wires, water pipes or any other obstructions, it is best to choose a different location for your bench. WARNING: You must mount your bench directly into the center of your wall’s wooden studs. DO NOT attempt to mount into steel studs or with any type of wall anchor. This will not provide adequate support.