Installation & Assembly

The tools you need are:
Stud Finder, Drill, 5/32" drill bit, #3 Phillips Screwdriver, 6" #3 Phillips Bit
Extension, 12" or longer Level, Tape Measure, and a Pencil.
Before beginning, check your box. It should contain the bench with pre-attached
mounting brackets and a hardware pack containing 6 #12x2-1/2" Marine Grade
Stainless Steel Phillips head screws. Test the bench locking mechanisms to
be sure that they operate properly. Pressing the tang at the front of bench will
activate the mechanism.
Step 1
Select the location for mounting the bench. Keep in mind that this bench is
collapsible so be sure that there is enough clearance for proper operation.
Step 2
Following the manufacturer’s instructions for your electronic stud sensor, locate
the wall studs. Depending on the type of stud sensor you have, you can also use
it to locate any electrical wires or other obstructions in the wall. If you nd
electrical wires, water pipes or any other obstructions, it is best to choose a
different location for your bench.
WARNING: You must mount your bench directly into the center of your wall’s
wooden studs. DO NOT attempt to mount into steel studs or with any type of wall
anchor. This will not provide adequate support.
Step 3
Measure up from the oor to the desired height of the bench. We recommend
a minimum of 13" to a maximum of 18" but you can vary this according to your
specic requirements. Make a mark on the wall for the height. Using your level,
mark a level horizontal line to reference as you continue.
WARNING: Be sure to include the thickness of the bench in your measurement
calculations.
Step 4
For easier mounting, the brackets on your bench are located at 16" on center, the
same as most wall studs. Following the illustration below, mark the locations of
the mounting holes for each bracket. You can also have someone hold the bench
in position while you mark the holes directly from the bracket.
Continued on back
3/16”
(5mm)
Vertical
Centering Line
1/2”
(12.7mm)
1”
(25.4mm)
2-5/8”
(67mm)
5/8”
(18mm)
1-3/4”
(45mm)
1-1/2”
(38mm)
Tang
7-3/4”
(196.85mm)
11-3/4” (298.45mm)
12-9/16” (319.09mm)
6-1/2” (165mm)
Teak Bench Top
1-1/4”
(31.75mm)
Teak Bench Top
1-1/4”
(31.75mm)
Side View
of Bracket
Bracket Shown
from Back Side