Owner Manual

nstructions: Series Wine Racks

Figure L

9. INSTALL MOUNTING HOLE CAPS

Press three (3) mounting hole caps— two (2) into the

½” holes on the face of the each Strip.

10. OPTIONAL: CONNECTING

STRIPS VERTICALLY

When stacking the Racks, connect another Strip to the

Plastic Coupler (Figure K). Ensure that the Strip is Plum

with a Level and mark the mounting holes. Then repeat

the previous steps to attach the Strip.

11. ADD WINE

Only the good stuff.

Maintenance and Care:

VintageView Series Wine Racks should be regularly

checked for tightness. Should any Rack to be found to

be loose, remove mounting hole covers and tighten with

screwdriver to secure.

If the face of the wall surface shows signs of break-age,

discontinue use immediately until the wall may be

adequately repaired. Series Wine Racks may be

cleaned with a damp cloth and mild dish soap. Abra-

sive pads or steel wool should NOT be used as they will

damage the finished surfaces of the parts.

Figure K