Installation Instructions

4. Hang the rst strip - Take a toggle bolt and remove the
expanding nut. Insert the bolt through the top mounting hole
of either the base or neck strip, as it corresponds with the bottle
direction chosen earlier. With the wings of the nut oriented to fold
toward the head of the bolt, thread the expanding nut onto the
bolt so the tip of the bolt starts to protrude from the end of the nut.
Hold the strip so the toggle bolt aligns with the 13/32 inch hole and
gently push the expanding nut through the wall (Figure E). Ensure
that the wings of the expanding nut have fully expanded on the
backsideofthewallandgentlytightenthebolt,veryingthatthe
bottom 2 mounting holes align with the anchors in the wall. Secure
the rest of the strip in place through the bottom two mounting holes
with the provided Screws (Figure F) and fully tighten the toggle bolt.
Note: For ease of removal when stacking racks, it is recommended
that the end plugs are taken out prior to installation.
3. Install the Anchors - For the lower 2 holes only, use a Phillips
head screw driver to screw the Spiral Drywall Anchors into the
wall at the marked hole locations until the head of the anchor is
ushwiththewallsurface(FigureC).FortheTOPmountingpoint,
drill a 13/32 inch (10.3mm) hole for a Toggle Bolt (Figure D).
Note: If a strip location is over a stud, the Toggle Bolt and Drywall
Anchors should not be used. Extra Screws are supplied and can be
used to directly fasten that strip into the stud.
Figure C Figure D
Figure E
5. Hang the second strip - Repeat Steps 2 through 4 with the
second strip, centering it horizontally with the second mark on
your wall from Step 1 and ensuring that the tops of the strips are
even with each other (Figure G).
Figure F
Figure G
6. Finish up - Install the mounting hole caps in the 1/2 inch holes
on the face of the rack by pressing into place (Figure H).
Figure H Figure I
Stacking racks - WS series racks are designed to stack, one
on top of the other. You may remove the pre-installed plastic
end plugs from the appropriate rack ends and use the
supplied couplers to align the two racks when stacking (Figure I).
For product warranty information, please visit us