Installation & Assembly

• (2) Steel Wine Wall Brackets

• ES Wine Rods (quantity varies

by conﬁguration)

Wine Wall Base Kit

ase Unit Installation Instructions (all sizes)

For installations using Wine Wall Expansion units, please refer to directions included with those

products.

Parts List

• ES Screws (2 per rod)

• (1) 5mm Allen key

• (4 or 6) M6 Toggle Bolts

• (4 or 6) Wood screws

• Measuring tape

• Pencil

• 4’ level

Required Tools

• Drill

• 5/8” Paddle drill bit

• 5/64” drill bit

• A handy friend

Step 1: Plot Mounting Holes

Position one Wine Wall Steel Bracket in desired place on

the wall — leaving a minimum of 1” clearance from ad-

jacent walls or obstructions — and mark locations of the

mounting holds. Ensure bracket is plumb by using a level.

Plot the mounting holes for the second bracket by measur-

ing 39-9/16”* from the ﬁrst brackets’ top mounting hole.

Use a level to be sure that the marks are aligned.

Step 2: Drill Mounting Holes

Using the smaller drill bit, drill a pilot hole to determine

if drywall or wood hardware is needed for installation. If

the surface is determined to be wood, drill remaining pilot

holes at the marked locations and move to step 3. If it is

determined to be drywall, use the 5/8” paddle drill bit to

drill holes in marked locations.

Note: For concrete, brick or stucco we recommend 3/16”

x 1-1/4” masonry screw (sold separately).

PAGE 1
Wine Wall Base Kit Base Unit Installation Instructions (all sizes) For installations using Wine Wall Expansion units, please refer to directions included with those products.
PAGE 2
Instructions Step 3: Build the Wine Wall Insert one Screw through the support fin on the Wall Bracket. Thread one Rod onto the Screw and fully tighten with provided 5mm allen key. Repeat for all support fins on both Wall Brackets. Step 4a: Mount the Wine Wall (drywall) Disassemble provided toggle bolts, removing each expanding nut. Insert the bolt through the mounting hole on the wall bracket.