Owner Manual

I
nstructions: Series Wine Racks
Figure E
3. MARK THE NEXT STRIP
For the second Mounting Strip location, use a level
to measure 7 1/2” (190.5mm) from one of the first
Mounting Strip holes and mark the location for the cen-
terline of the second Strip (Figure B).
Hold the second Mounting Strip in place against the
wall centered on the mounting mark. Ensure the Strip is
plumb using a Level and mark the hole locations with a
Pencil. Double check the locations are level with those
marked for the first Strip. Set the Strip aside.
If Installing racking for 375mL bottles, use 5½”
(139.7mm) for centerline.
IMPORTANT: If installing Series Magnum or Series Big
Bottle Racks, reference specific instructions for proper
centerline distances.
4. (OPTIONAL) MEASURE
ADDITIONAL COLUMNS
If installing multiple columns, mark the centerline for the
next Strip 5 1/2” (140mm) from the second mark, and
mark again 7 1/2” (190.5mm) for the distance be-
tween the Neck and Base Strips (Figure C).
Note: For non-standard layouts or bottle sizes such as
a Split or Half, subtract 2” (51mm) from the Centerline
to determine the distance between wine rack columns,
then proceed with respective centerline for layout out the
Neck and Bas Strips for the next column.
5. (OPTIONAL): PREPARE RACKS TO STACK
Series Wine Racks are designed to stack, one on top of
the other. If connecting Racks vertically, remove the
Endcaps from the Strips before mounting to the wall and
replace them with supplied Couplers.
6. DETERMINE WALL SURFACE
Drill 1/16” (1.5mm) pilot holes at the marked locations
to determine if installing into drywall or wood studs/
backing.
Figure E
Figure C
Figure D
Figure F