Owner Manual

I
nstructions: Series Wine Racks
7. DRILL MOUNTING HOLES
For Drywall
For the top mounting point, drill a 13/32” (10.5mm)
hole for a Toggle Bolt. For the lower two holes use a
Phillip’s head screw driver to screw the Spiral Drywall
Anchors in the wall until the anchor is flush with the wall
(Figure G).
For wood or stud
Skip to end of step 8.
8. HANG THE STRIPS
For Drywall
Insert one Toggle Bolt into the top mounting hole of either
the Base or Neck Strip (Figure H). With the wings of the
Expanding Nut oriented to fold toward the Bolt head,
thread the Expanding Nut onto the Bolt so that the tip of it
starts to protrude from the end of the nut.
Hold the Strip so the Bolt aligns with the top mounting
hole and gently push the Nut through the wall. Ensure the
wings have fully expanded on the back side of the wall
(Figure I).
Important: If the Expanding Nut does not fully open
behind the wall, the Mounting Strip may come out of the
wall.
Secure the bottom of the Strip using two (2) screws — one
(1). Verify the Strip is Plumb and fully tighten the Toggle
Bolt using a Phillips Head Screw-driver.
Repeat with Second Strip.
For Wood
Attach one (1) Neck Strip and one (1) Base Strip to the
wall at marked hole locations using six (6) Screws — four
(4)(Figure J). Ensure each Strip is Plumb and level before
fully tightening.
Figure I
Figure E
Figure G
Figure H
Figure J