Installation Instructions

Wall Series
• 1 Base strip
• 1 Neck strip
• 4 or 6 mounting hole caps
• 2 Plastic Couplers
• 2 or 4 Spiral drywall anchors
• 4 or 6 screws
• 2 toggle bolts
• Phillips head screw driver
• Level
• Pencil
• Tape Measure
• Drill
Parts List Required Tools
holes at the marked locations to check for studs or
wood backing.
Pro Tip: If installing multiple columns, mark the
centerline for the next strip 5½” (139.7mm) from the
second mark and mark again 7½” (190.5mm) from
that mark for the distance between the neck and the
base strips. To lay out additional columns, mark the
wall, alternating between 5½” and 7½”
Smaller bottles: If Installing racking for 375mL
bottles, we recommend adjusting the 7½” centerline
dimension to 5½” (139.7mm) between the base and
neck strips.
Installation Notes:
If installing Wall Series racks to a Wall Series Frame, use the self-drilling screws and instructions supplied with
the frame to attach racking.
For concrete, brick or stucco installs, use 3/16” x 1¼” masonry screw or #8 x 1¼” screw with appropriate
size expanding concrete anchor (not included)
1. Choose bottle direction — Decide if you want the necks of the bottles facing left or right, and
identify the base from the neck strip (base features wider support divits that rest lower on the frame).
Figure A Figure B
3. Mark the hole location for the strip —
Hold either the neck or base strip of the rack in place
against the wall, centered on the rst mark the appro-
priate distance above the oor. Ensure that the rack is
plumb using a level and mark the hole locations with a
pencil. Set the strip aside.
4. Check for Studs – Drill 1/16” (1.5mm) pilot
2. Lay out the wall — Starting at least 2¾” (70
mm) from adjacent wall or other obstructions, mark the
centerline of the rst strip. From there, measure 7½”
(190.5mm) from that mark for the distance between the
neck and the base strips.
Installation Instructions for all standard bottle sizes