Installation & Assembly

ManualsBrandsRebrilliant ManualsCloset Storage & OrganizationSavanah 34.75'' Clothes Rack

Folding Garment Rack

A 1 ea

Hanging chrome tube

E 2 ea

Locking connector

I 4 ea

Washer

L 2 ea

End plug

O 1 ea

Hex wrench

M 2 ea

Wheel

N 2 ea

Wheel with lock

J 4 ea

Small screw

K 4 ea

Hex screw

F 4 ea

Base connector

G 2 ea

End cap

B 2 ea

Vertical chrome tube

C 4 ea

Vertical bent tube

D 2 ea

Horizontal tube

Assembly

Time:

Less than

30 minutes.

This product's

intended use is for

hanging garments.

Tools Needed:

Phillips screwdriver.

STEP 1. Leg assembly: Insert two vertical bent

tubes (C) into underside of a locking connector (E).

Line up the tubes to match the drawing below.

Assemble with two washers (I), two hex screws (K),

and two acorn nuts (H). Tighten with hex wrench (O).

Install a base connector (F) to each end of vertical

bent tubes (C) using a small screw (J). Loosely

tighten screw with a Phillips screwdriver (not

included) (See note below). Repeat this step for the

other leg assembly.

STEP 3. Hanging bar assembly:

Install two end caps (G) onto each

end of hanging chrome tube (A).

Insert two vertical chrome tubes (B)

into bottom of end caps (G). Insert

two end plugs (L) into bottom of

vertical chrome tubes (B).

STEP 4. Unlock the locking

connectors (E) and slide the

hanging bar assembly through

the top of the locking connector

to the desired position. Lock the

locking connector. Assemble

the wheels (M & N) to the

bottom of base connectors (F).

STEP 2. Insert two horizontal tubes (D) between

the two leg assemblies and push the leg assemblies

together. Place on a hard even surface and square

all parts up. Now, tighten small screws (J) using a

Phillips screwdriver.

NOTE: Generally position base

connector (F) on the end of vertical

bent tube (C) as this drawing shows.

However, wait to tighten the small

screw (J) until step 2 below.

H 4 ea

Acorn nut

Summary of content (1 pages)

PAGE 1
Folding Garment Rack A 1 ea H 4 ea Acorn nut E 2 ea Hanging chrome tube Locking connector Washer Vertical chrome tube J 4 ea G 2 ea K 4 ea Hex screw End cap STEP 1. Leg assembly: Insert two vertical bent tubes (C) into underside of a locking connector (E). Line up the tubes to match the drawing below. Assemble with two washers (I), two hex screws (K), and two acorn nuts (H). Tighten with hex wrench (O). Install a base connector (F) to each end of vertical bent tubes (C) using a small screw (J).