Owner Manual

ManualsBrandsRebrilliant ManualsBarwareIndurial Wall Mounted Wine Bottle Rack

Series Wine Racks

Installation instructions

Included Parts

• (1) Base strip

• (1) Neck strip

• (4) or (6) mounting hole caps

• (2) Plastic Couplers

• (2) or (4) Spiral drywall

anchors

• (4) or (6) screws

• (2) toggle bolts

Required Tools

• Phillips head screw driver

• Level

Important Note: This installation guide will assist you with installing the VintageView Series Wine Rack into

wood-backed or drywall surfaces. These models are suitable for most 750ml bottle sizes; use Series Magnum

Rack for Champagne storage.

If installing racks to Series Frames, please use the install guide and hardware included with Frames.

Figure A Figure B

1. CHOOSE BOTTLE DIRECTION

Decide if you want the necks of the bottles facing left or

right, and identify the base from the neck strip (base fea-

tures wider support divots that rest lower on the rack).

2. MARK THE FIRST STRIP

Starting at least 2¾” (70mm) from adjacent wall or

other obstructions for Split or 750ml wine bottles.

Hold the ﬁrst Mounting Strip in place against the

wall in desired location (Figure A). Ensure the Strip is

plump using a Level and mark the hole locations with

a Pencil. Set the Strip aside.

3D-GUID EMBLY

INSTRUCTI

• Pencil

• Tape Measure

• Drill

• 1/16” (1.6mm) Drill Bit

• 13/32” (10.5mm) Spade Bit

Summary of content (4 pages)

PAGE 1
Series Wine Racks Installation instructions 3D-GUID INSTRUCTI Included Parts • • • • • (1) Base strip (1) Neck strip (4) or (6) mounting hole caps (2) Plastic Couplers (2) or (4) Spiral drywall anchors • • (4) or (6) screws (2) toggle bolts Required Tools • • Phillips head screw driver Level EMBLY • • • • • Pencil Tape Measure Drill 1/16” (1.6mm) Drill Bit 13/32” (10.
PAGE 2
Instructions: Series Wine Racks 3. MARK THE NEXT STRIP For the second Mounting Strip location, use a level to measure 7 1/2” (190.5mm) from one of the first Mounting Strip holes and mark the location for the centerline of the second Strip (Figure B). Hold the second Mounting Strip in place against the wall centered on the mounting mark. Ensure the Strip is plumb using a Level and mark the hole locations with a Pencil. Double check the locations are level with those marked for the first Strip.
PAGE 3
Instructions: Series Wine Racks 7. DRILL MOUNTING HOLES For Drywall For the top mounting point, drill a 13/32” (10.5mm) hole for a Toggle Bolt. For the lower two holes use a Phillip’s head screw driver to screw the Spiral Drywall Anchors in the wall until the anchor is flush with the wall (Figure G). Figure G For wood or stud Skip to end of step 8. 8. HANG THE STRIPS Figure E Figure H For Drywall Insert one Toggle Bolt into the top mounting hole of either the Base or Neck Strip (Figure H).
PAGE 4
Instructions: Series Wine Racks 9. INSTALL MOUNTING HOLE CAPS Press three (3) mounting hole caps— two (2) into the ½” holes on the face of the each Strip. 10. OPTIONAL: CONNECTING STRIPS VERTICALLY When stacking the Racks, connect another Strip to the Plastic Coupler (Figure K). Ensure that the Strip is Plum with a Level and mark the mounting holes. Then repeat the previous steps to attach the Strip. Figure K 11. ADD WINE Only the good stuff.