Owner's Manual

STEP 2
Screw each CASTER (I & J) into the bottom of
each BOTTOM POLE (C). Turn clockwise to
screw in place. Use the wrench to tighten
each CASTER (I & J) . Make sure LOCKING
CASTERS (I) are on the same side.
Use the provided caster wrench to tighten
completely. Failure to do as instructed
could result in the caster stem breaking.
C (4) J (2) K (1)I (2)
C (4)
G (8)
Note that each POLE (B & C) has slight horizontal line
indentations at 1” intervals. Each SLIP SLEEVE (G) has raised
horizontal lines inside designed to lock in place on POLE (B
& C).
Slide the pair of SLIP SLEEVES (G) until you hear a click to
confirm the pair is locked onto BOTTOM POLE (C). DO NOT
place more than one pair on each POLE (B & C) at one time.
Note: There will be a very small gap in-between two locked SLIP SLEEVES (G)—this is normal.
ASSEMBLY INSTRUCTIONS
STEP 1
2
On BOTTOM POLE (C), place 1 pair of SLIP SLEEVES (G) at
the desired level no higher than the 3
rd
indentation from
the bottom. Please make sure the arrow on SLIP SLEEVES
(G) faces up and that the word “TOP” is right side up. Do
this for each BOTTOM POLE (C) and make sure slip sleeve
heights are identical for all (4) BOTTOM POLE (C).