Owner`s manual

STEP 5 – Install Smart Grill Technology™ Controller
A Find the metal bottom shelf. Insert the two white braided RTD wires through the grommet a
shown illustration 1.
B Plug the two white braided RTD wires onto the tabs b labeled ‘RTDA’ where indicated in
illustration 2. Slide them firmly onto the connectors and be careful to not touch any other parts of
the circuit board.
Replace the shelf cover with the 4 included sheet metal screws.
C Connect the wiring harness from the Smart Grill Technology™ controller unit to the grill body
wiring harness. The two connectors are shown in illustrations 3.
6 ©2014, Rec Tec Industries, LLC
a Shelf Grommet
b Two ‘RTDA’ Tabs
on circuit board.
Illustration 1
Illustration 2
Illustration 3
c Connect the wiring harnesses.
Female connector, from Smart
Grill Technology™ controller
Male connector, from grill body