Instruction manual

2322
WARNING!
DEATH or SERIOUS INJURY
can occur
7. Tighten harness by pulling
the adjuster strap straight out
through the adjuster ap. The
harness webbing should be
snug around the child in both
the lap and shoulder sections.
8. Slide the chest clip so it is at
the child’s armpit level.
9. The harness is tight enough
when you cannot pinch a
loop of webbing between
two ngers at the child’s
collarbone.
Section 9: Positioning Your Child in the
Harness Mode
1. Loosen the harness system. Pull
up on the adjuster lever located
under the trim cover adjuster
ap and pull the shoulder straps
forward.
4. Place the child in the child restraint
with their bottom fully into the seat.
Position the harness straps around
the child and fasten both latch
plates into the buckle.
3. Open the 5-point integrated
harness buckle by pressing the red
button in the center of the buckle.
Place harness straps to the side.
5. Fasten chest clip.
6. Pull up on each shoulder strap
to tighten the lower section of
the harness.
2. Open the chest clip by squeezing
in the center and separating.
Section 9: HARNESS MODE Positioning Your Child
Do NOT use the child restraint in the Harness Mode:
• If the harness straps are BELOW
the child’s shoulders when the head
restraint is adjusted to its upper-
most position.
• If the child’s ears are ABOVE
the top edge of the head restraint
when the head restraint is in its
highest position. It is important
if any portion of the child’s head
exceeds the top of the child
restraint, there must be a vehicle
headrest support.
Section 9: HARNESS MODE Positioning Your Child
1
2
3
4
5
7
8
9