Datasheet

18
www.recom-electronic.com
REV: 3/2011
Please Read Application Notes
LIGHTLINE
AC/DC-Converter
with 5 year Warranty
RACD12
RACD12
12 Watt PFC
Single
Output
● 12W Class II AC/DC LED Power Supply
● 350mA or 700mA Constant Current Output
● Drives 1 - 10 High Brightness LEDs
● Universal AC Input
● Active Power Factor Corrected >0.95
● Fused Input, Protected Output
● 3kVAC Input/Output Isolation
● Output Socket Connector
● cUL/UL-8750 Certified
● Low Cost
● Long 5 Year Warranty
Features
LED
DRIVER
Selection Guide
Part Nominal Input Current Output Output Max
Number Input Voltage at 230VAC Voltage Range Current #
(VAC) (mA) (VDC) (mA) LEDs
RACD12-350 universal 200 3-36 350 10 x 1W
RACD12-500 universal 200 3-24 500 6 x 2W
RACD12-700 universal 200 3-17 700 4 x 2W, 8 x 1W
Input Voltage Range 90VAC-264VAC
Rated Power 12 Watts max.
Input Frequency Range 47-63 Hz
Power Factor Full Load, 115VAC/230VAC 0.95
Open Circuit Voltage 350mA Version 39VDC
(Zener Clamp) 500mA Version 26VDC
700mA Version 19VDC
Inrush Current (<2mS) 115VAC/230VAC 10A max.
Input Current 230VAC, Full Load 200mA max.
Leakage Current 115VAC/240VAC - 60/50Hz 0.5mA typ.
Input Fuse Standard T1A
Output Current Accuracy (combined Tolerance, Load Regulation and Line Regulation) ±10%.
Minimum Load Open Circuit Protected 1 LED
Output Ripple 150mA max.
Hold Up Time 18ms min.
Operating Frequency 50-120kHz typ.
Efficiency at Full Load 78%
RMS Isolation Voltage (input to output) 3kVAC / 1 minute
Temperature Coefficient ±0.02%/°C typ.
Overload Protection 120% typ.
Short Circuit Protection Continuous Current Limit
Output Overvoltage Protection Zener Diode Clamp
continued on next page
Description
Specifications
(typical at 25°C and after warm up time unless otherwise specified )
A compact 12W constant current switching power module suitable for driving up to ten high power LEDs (Vf = 3.6V).
The output current is fixed at 350mA, 500mA or 700mA. Active power factor correction is standard and the converters
are UL8750 certified for use with LED assemblies. The driver modules features both screw terminal and socket output
connections. The socket connecter avoids the possibility of miswiring and damaging the LED load if the LEDs are pre-
assembled into a wiring harness or lamp fitting.
UL-8750 Certified
cUL-8750 Certified
EN 61347 Certified
E340696
RoHS
2002/95/EC
6/6