Installation manual

3
MAIN PARTS AND WORKING PRINCIPLE
1. CPU Cooling Block: Specifically designed for the heat transfer process from
the CPU core.
2. Pump: will provide power for the circulation of the coolant.
3. Radiator & Fan: Also know as the Heat Exchanger, for dispersing heat from the
coolant
4. Mounting Plate: for 1156 (i5), 1366(i7), LGA775, AM3/AM2(+), 754 / 939 / 940 / 478
5. Heat-Transferring Liquid: Liquid coolant, used to transfer heat from the
system. Ready-to-use (doesn’t have to be diluted with distilled water anymore)
6. Thermal compound: Used to increases heat transfer from the heat source to
the cooling block.
7. Tubing: Used to direct coolant around the system.
8. Fittings: Used to fix hose on the liquid cooling components.
Installation
SET UP YOUR WORK AREA
Your working area should be well lit at all times, gather your tools: screwdriver;
scissors etc.
Installation of the CPU Block
Warning: Please take care while installing the CPU-Block. Fixing too hard using
tools might cause damages to the CPU and M/B!
1. Please remove the retention module from the M/B if necessary. The M4 screws have to
be put through the M/B from the bottom side. Please make sure that the washer and
insulating is placed in between as shown on the picture.