Datasheet

DC/DC Converter
RPP-5
REV.: 3/2016www.recom-power.com
in
5µH 50Ω
LISN
out
rcvr
rcvr
in
5µH 50Ω
LISN
out
+
-
DC
Power
Source
1m Twisted Pair
50 Ohm termination
Printed Circuit Board
Resistive
Load
Product
Optional Connection
to Earth Ground
50 Ohm input
Filter
(if used)
Computer
EMC
Reciever
DIMENSION AND PHYSICAL CHARACTERISTICS
Parameter Value
Material
(3)
Aluminium
Package Dimension (LxWxH) 40.6 x 25.4 x 12.7mm
Package Weight 27g
INSTALLATION and APPLICATION
Specifications (measured @ ta= 25°C, nominal input voltage, full load and after warm-up)
RPP20-2405SW
Series
1
2
3
4
56
Bottom View
dia. 1.0
20.32
11.68
10.16
5.08
7.62
10.16
9.14
2.54
25.4
4.32
5.08
Sandoff
=1.02
40.6
Dimension Drawing (mm)
Notes:
Note3: To ensure a good all-round electrical contact, the bottom plate is pressed firmly into place into the aluminium case.The hydraulic press can
leave tooling marks and deformations to both the case and plate. The case is anodised aluminium, so there will be natural variations in the case
colour and the aluminium is not scratch resistant. Any resultant marks, scratches and colour varations are cosmetic only and do not affect the
operation or performance of the converters.
Test Set-up
The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOM’s explicit written
consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall
indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications.
PACKAGING INFORMATION
Parameter Type Value
Packaging Dimension (LxWxH) Tube 160.0 x 45.0 x 16.0mm
Packaging Quantity
5pcs
Storage Temperature Range -55°C to +125°C
Pin Connections
Pin # Single
1 +Vin
2 -Vin
3 +Vout
4 Trim
5 -Vout
6 CTRL
Tolerance: ±0.8mm