Specifications

13.0 KEYPAD CONTROL

The drive can be operated in a number of different ways: keypad (LOCAL), control devices

wired to the terminal strip (REMOTE), serial communications (SERIAL), or combinations of

each. The drive should first be operated from the keypad during initial start-up. Refer to

Sections 14.0 - CONTROL WIRING, and 18.0 - DESCRIPTION OF PARAMETERS for

information on remote operation.

13.1 KEYPAD FUNCTIONS

START/STOP To start the drive, press the START key. To stop the drive,

press the STOP key.

NOTE 1: A jumper may need to be installed between TB-1

and TB-2 in order to START the drive in LOCAL mode (refer

to Parameter 30 - CONTROL).

NOTE 2: The STOP key is active in both LOCAL and

REMOTE modes.

SPEED SETPOINT To increase the speed setpoint, press the V key. To decrease

the speed setpoint, press the W key.

NOTE: The V and W keys are only active if another speed

reference source is not selected.

LOCAL/REMOTE To toggle between LOCAL and REMOTE mode, press the

LOCAL/REMOTE key to select the desired mode, and then

press the ENTER key within three seconds to confirm the

change.

NOTE: Parameter 30 - CONTROL must be set to KEYPAD

or KEYPAD 2 for this key to be active.

AUTO/MANUAL To toggle between AUTOMATIC (terminal strip) and

MANUAL (keypad) speed control, press the AUTO/MAN key

to select the desired mode, and then press the ENTER key

within three seconds to confirm the change.

NOTE: Parameter 28 - AUTO/MAN must be set to A/M LOC

or A/M SPD for this key to be active. See Section 14.0 -

CONTROL WIRING for information on automatic speed

reference sources.