Specifications

16.0 PROGRAMMING THE AC400 DRIVE

16.1 PROGRAMMING THE PARAMETERS

The AC400 keypad serves two purposes: operating the drive when in the LOCAL mode, and

programming the parameters for particular applications. The keypad is shown below, along

with the display that should appear when the drive is first powered up:

To program the drive, the PROGRAM mode must be entered by pressing the PROG/RUN

button. If the password protection is disabled, pressing the PROG/RUN button will result in

direct entry into the PROGRAM mode. If the password protection is enabled, the

PASSWORD prompt will appear when an attempt is made to enter the PROGRAM mode.

The PASSWORD prompt appears as follows:

To enter the password, use the UP and DOWN arrow keys to scroll to the password value,

and then press the ENTER key.

NOTE: The factory default password is 0019.