Specifications

44
Once the correct password is entered, the PROGRAM mode will be entered and the first
parameter will be displayed, which is Parameter 0 - LINE VOLTS. This is shown below:
To scroll through the parameters, use the UP and DOWN arrow buttons on the keypad.
When the desired parameter is found, press the ENTER key to shift the cursor from the
parameter name to the parameter value. In this example, the cursor shifts from LINE
VOLTS to AUTO:
The parameter value can then be changed using the UP and DOWN arrow buttons. If the
parameter has a numerical value, the UP arrow will increase the value and the DOWN arrow
will decrease the value. If the parameter has specific choices that can be selected, the UP
and DOWN arrow keys will scroll through the list of possible settings. When the desired
value or option is selected, press the ENTER key to store the new setting. If the new setting
is not ENTERED, it will not take effect and the old setting will still be valid.
If the PROG/RUN key is pushed while the cursor is highlighting the parameter value, the
value will change back to the original setting (if it had been changed, but not ENTERED),
and the cursor will shift back to the parameter name. Pressing PROG/RUN again will exit
the PROGRAM mode. If the PROGRAM mode is entered again within two minutes, the last
parameter that was viewed, or changed, will come up on the display. After two minutes has
elapsed, the password will have to be entered again when attempting to access the
PROGRAM mode.