Specifications

A/M SPD The AUTO/MAN key is always active.

NOTE: If the drive is switched from LOCAL to REMOTE mode, speed

control will switch to AUTO. If the drive is switched from REMOTE to

LOCAL mode, speed control will switch to MANUAL mode. The

AUTO/MAN key can then be used to select the desired mode.

30 CONTROL (START/STOP CONTROL)

This parameter selects the START/STOP control source, which is either the keypad

(LOCAL), the terminal strip (REMOTE), or the serial link (SERIAL). The

LOCAL/REMOTE key on the keypad is also affected by the setting of this parameter. The

following settings are possible:

LOCAL The drive will only respond to START/STOP commands from the

keypad. The LOCAL/REMOTE key is disabled.

REMOTE The drive will only respond to START/STOP commands from the

terminal strip. The LOCAL/REMOTE key is disabled.

SERIAL The drive will only respond to START/STOP commands through the

serial link.

KEYPAD The LOCAL/REMOTE key on the keypad is enabled and is used to

toggle between LOCAL and REMOTE modes. Press the

LOCAL/REMOTE key to select the desired mode and then press the

ENTER key within three seconds.

NOTE: If LOCAL mode is selected, a jumper is required between TB-1

and TB-2 to allow the drive to START.

TB STRIP The terminal strip is used to select LOCAL or REMOTE mode. LOCAL

mode if TB-13A or TB-13C is set for LOCAL SELECT and a contact

closure is made between TB-13A or TB-13C and TB-2. If the contact

closure is not made, the drive will be in REMOTE mode.

KEYPAD 2 Acts the same as KEYPAD, but TB-1 is disabled as a STOP input when

LOCAL mode is selected. Therefore, a jumper is not required between

TB-1 and TB-2 to START in LOCAL mode.

NOTE 1: The STOP key on the keypad is always active. The STOP

input at TB-1 is always active unless CONTROL is set to KEYPAD 2

and LOCAL mode is selected.