User Manual

IV. Tuning the Headphones

1. Push the power/scan control (F) to turn the headphones ON. The power

indicator light (E) will illuminate red. The tuning indicator light (G) will

illuminate green, indicating that the headphones are tuned to the

transmitter. You should hear sound coming from the headphones.

2. Adjust the volume (D) as desired.

3. The headphones will automatically retune if they lose the signal from the

transmitter. However, you can also push the power/scan control button (F)

to retune the headphones at any time. Allow 10 to 15 seconds for the

headphones to lock into the transmitter. The green “tuned” indicator light

will come on after the headphones have been successfully tuned.

Note: Interference in the form of static and/or distortion can sometimes

be heard. If this occurs, confirm the transmitter/headphone adjustments and

indicators. If the problem persists, refer to the Troubleshooting section of

this manual.

D. Volume control

E. Power indicator light

V. Turning the Headphones Off

1. Press and hold the power/scan control button (F) for about 2 seconds to

turn the headphones OFF. The red power LED light (E) will go off to

indicate that the headphones have been turned OFF.

2. Place the headphones on the transmitter to recharge the batteries.

Note: Only the rechargeable NiMH and NiCd batteries can be charged.

Please refer to the Charging Batteries section of this manual on page 5 for

detailed instructions.

F. Power/scan control (on/off tuning)

G. Tuning indicator light