Operating instructions

ManualsBrandsRectella ManualsHeater1622 Instove INSET

Installation and Operating Instructions Reference: 1622 Rectella Instove INSET BQ2104-1d Oct 2011

1622 Instove

INSET

INSET SOLID FUEL

ROOMHEATER

FOR INSTALLATION IN

STANDARD BRITISH or IRISH

FIREPLACES CONFORMING TO

BS1251 & BS8303

(Measurements include decorative frame)

INSTALLATION AND OPERATING INSTRUCTIONS

LEAVE THIS DOCUMENT WITH THE HOUSEHOLDER!

Intermittent burning solid fuel room heater for installation in

masonry fireplace with a single dedicated chimney.

Wood logs Mineral fuel (Ancit)

Approx. efficiency 78% 76%

Nominal Output 4.9Kw 3.0kW

Minimum clearance to

combustible materials

Must be maintained

Top: 400mm

All other faces: 250mm

EN 13229

Manufactured for Rectella International Ltd, Bancroft Road, Burnley, Lancs, BB10 2TP

Tel: 01282 478200

Web: www.barbequick.com

Read these instructions! Use only recommended fuels!

Summary of content (12 pages)

PAGE 1
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET BQ2104-1d Oct 2011 1622 Instove INSET INSET SOLID FUEL ROOMHEATER FOR INSTALLATION IN STANDARD BRITISH or IRISH FIREPLACES CONFORMING TO BS1251 & BS8303 (Measurements include decorative frame) INSTALLATION AND OPERATING INSTRUCTIONS LEAVE THIS DOCUMENT WITH THE HOUSEHOLDER! Intermittent burning solid fuel room heater for installation in masonry fireplace with a single dedicated chimney.
PAGE 2
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET Contained in this box are the following components 1 x Sealing rope 1 x Double sided sticky tape for fixing the sealing rope 1 x Flue collar 2 x Flue collar bolts, nuts and washers 1 x Primary air slider and slider knob Box contents 4 x Stove securing bolts and washers 1 x Operating tool Flue collar Primary air slider Fixing Kit comprises a sealing rope and double sided sticky tape for fixing the rope to the rear face of the
PAGE 3
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET IMPORTANT Co2 DETECTOR It is the responsibility of the installer to fit a fully operational Co2 detector in the same room as this appliance. INSTALLATION THIS APPLIANCE CAN PRODUCE POISONOUS GASES IF NOT FITTED CORRECTLY. THE STOVE AND ITS SURROUND CAN BECOME EXTREMELY HOT A fire-guard should be used if children or infirm persons are present.
PAGE 4
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET FITTING: Referring to Fig 6, 7 and 8, peel off one side of the protective film and apply the double sided tape to the rear of the stove edges (as in Fig 6) pressing down firmly to make sure of good adhesion, then peel away the second side protective film and apply the soft rope seal to the sticky double sided tape (Fig 7) with a finished rope seal all the way round (Fig 8).
PAGE 5
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET Primary air slider – Assemble the slider from the inside of the door. Push the slider bar bolt through the hole in the door and then tighten the slider knob ensuring that the slider is free enough to slide back and forth. Make sure that the slider slides and that the air holes line up. (Fig 18) (Fig 19) (Fig 18) Primary air slider kit.
PAGE 6
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET OPENING THE DOOR This stove is designed to be operated only with the door closed. Open the door very slowly to minimise fume emission and prevent hot fuel falling out. FUELS There is no 'perfect' fuel, so we strongly recommend that you try a selection of fuels (or mixtures) to find which suits you best. Do avoid dusty materials like sawdust; they can burn far too violently.
PAGE 7
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET Operation to Avoid Smoke Emission when Loading and Re-lighting To prevent the likelihood of smoke emission it is advised that: The appliance is not overloaded Fuel should be added to fill the stove criss-cross, so air can circulate between logs. Fuel should be added 'little and often' Always have the air wash control (1) at least a little open.
PAGE 8
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET MAINTENANCE ANNUALLY- SWEEP THE CHIMNEY The entire length of the chimney from stove to outlet should be swept annually or more often if smoky fuels are used. SUMMER SHUT DOWN: Before a long period of non-use, empty fuel and ash, remove the throat plate and leave all the air controls open to allow ventilation to reduce condensation.
PAGE 9
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET ORDERING NEW PARTS – Please use the item list below whenever you need to order. ITEM NO.
PAGE 10
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET TO FIND A QUALIFIED INSTALLER, FUEL SUPPLIER or CHIMNEY SWEEP, CONTACT: UK: The Solid Fuel Association, 7 Swanwick Court, Alfreton, Derbyshire DE55 7AS Tel:0845-601-4406 www.solidfuel.co.uk RoI: Irish Nationwide Fireplace Organisation, 162 Chapel Street, Dublin 1 Tel:01-801-5959 www.fireplace.
PAGE 11
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET 11
PAGE 12
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET 12