Operating instructions

Installation and Operating Instructions Reference: 1622 Rectella Instove INSET
2
Contained in this box are the following components
1 x Sealing rope 1 x Double sided sticky tape for fixing the sealing rope 4 x Stove securing bolts and washers
1 x Flue collar 2 x Flue collar bolts, nuts and washers 1 x Operating tool
1 x Primary air slider and slider knob
Box contents Flue collar Primary air slider
Fixing Kit comprises a sealing rope and double sided sticky tape for fixing the rope to the rear face of the inset before installation
(See fixing drawing page 4), four securing bolts and washers for securing the stove to your chimney breast and a flue collar to
attach the stove to your flue liner if required.
IMPORTANT: Remove all the packaging from around the upturned grate and turn the grate over from the packed position (Fig 3) to
stand upright on the four legs (Fig 4) before using for the first time.
(Fig 3) Grate as packaged upside down. (Fig 4)
Grate as it should be at first use.
DEFRA Approval
Note! in a smoke control zone to comply with DEFRA regulations, when burning wood the appliance must be fixed with a
mechanical stop to ensure the top air wash remains open.
(Fig 5)
Locking screw
An additional screw is fixed to the body to lock the top air control open for
burning wood when installed in a smokeless zone. (See Fig 5). This may
be removed if you are not within a smokeless zone or do not intend to burn
wood.