Operating instructions

Installation and Operating Instructions Reference: 1622 Rectella Instove INSET
4
FITTING:
Referring to Fig 6, 7 and 8, peel off one side of the protective film and apply the double sided tape to the rear of the stove edges (as
in Fig 6) pressing down firmly to make sure of good adhesion, then peel away the second side protective film and apply the soft rope
seal to the sticky double sided tape (Fig 7) with a finished rope seal all the way round (Fig 8).
(Fig 6) (Fig 7) (Fig 8)
Pu
sh the stove into the fireplace opening, ensuring that the rope seal on the rear of the stove forms an absolutely airtight seal
against the fireplace. In some cases it may be necessary to knock-out part of the old fireback.
Secure the stove using the stove securing bolts into the upper left and right fixing holes and into the bottom left and right fixing holes
(F) Fig 10. It is not necessary to fill any small gap behind the appliance – larger gaps can be filled with rubble, vermiculite granules
or mineral fibre.
F F
(Fig 9) F (Fig 10) F
If fitting a flue liner, remove the baffle plate (as shown on page 8) and reach up through the stove and pull the stove collar down and
secure the flue collar to the stove with the two flue collar bolts, nuts and washers as in Fig 11 and Fig 12 with a finished and secure
flue collar as in Fig 13. (Flue liner not shown for description purposes).
(Fig 11) (Fig 12) (Fig 13)
If fitting a flue liner, attach the flue collar to the flue liner. You may require a special appliance connector from the liner to the stove.
These are available to suit various sizes of flue liners and may need self tapping screws and fire cement to fix in position.
Align the collar so that the flue collar fixing holes on the stove are aligned with the fixing holes on the flue collar.