Operating instructions

Installation and Operating Instructions Reference: 1622 Rectella Instove INSET
8
MAINTENANCE
ANNUALLY- SWEEP THE CHIMNEY The entire length of the chimney from stove to outlet should be swept annually or more often if
smoky fuels are used.
SUMMER SHUT DOWN: Before a long period of non-use, empty fuel and ash, remove the throat plate and leave all the air controls
open to allow ventilation to reduce condensation.
NEW PARTS - Your stove has been extensively tested for safety - please don't try to modify it and always make sure to obtain genuine
spare parts.
Your stove generates VERY high temperatures. Eventually the internal parts will require replacement. Fig 14 shows the internal layout
of your stove. A full list of replacement parts can be found on page 9 of the instruction booklet.
Help
parts to last by:
 Using only recommend, very dry, fuels.
 Emptying the ash very regularly when using mineral fuel -never allow it to touch the underside of the grate.
 Cleaning the throat plate regularly.
 Avoiding 'over-firing'
BAFFLE PLATE TOP BRICK SIDE BRICKS
BASE BRICK BACK BRICKS (Fig 15) Operating tool
)41 giF(
The operating tool is used for opening the fire door, removing the ashpan and moving the primary and secondary air sliders.
IMPORTANT: The operating tool MUST be used for opening and closing the stove door.
Excessive force closing the door by hand may result in the door glass breaking and this will
not be covered under the stoves warranty.
Baffle plate removal - Should you wish to sweep the chimney then remove the baffle plate by taking out the two support pins in the
side bricks in the top of the stove that hold the baffle plate in place (Fig 16 and 17)
(Fig 16) (Fig 17)