Specification

DESCRIPTION:

RectorSeal® HI-TEMP 100% RTV silicone caulk is a one component sealant which cures to a strong durable

resilient elastomer. It will adhere to glass, clean metal, most types of non-oily woods, vulcanized silicone rubber,

silicone resins, natural and synthetic fibers, ceramic, paper, as well as many painted and plastic surfaces.

Meets the following specifications: USDA for use in federally inspected meat and poultry plants. F.D.A. reg. #21

CFR 177.2600, TT-S-001543A (COM-NBS) Class A, TT-S00230C (COM-NBS) Class A A MIL-A-46106B Amend

3, Type 1, and Canadian 19-GP-9MA, Type 1.

CHARACTERISTICS:

• -75½ to +650½ F Service Temp • Insulates

• Vibration Resistent • Bonds

• Remains Flexible • Seals

• USDA Approved

APPLICATIONS:

RectorSeal® HI-TEMP caulk can be used for bonding gaskets in heating and refrigeration units, filleting and

caulking joints in sheetmetal stacks, ductwork and equipment housing, sealing windows in oven doors and flues

on gas appliances, flanged pipe joints and access doors, glaze windows, and anywhere a tight leakproof seal is

required to weatherproof, protect and insulate. RectorSeal®HI-TEMP can be used to control noise and vibration

and as a pipe and tank sealer.

PACKAGING:

Code Size Qty. Per Case Lbs. Per Case Cu. Ft. Per Case

57500 10.1 Fl. Oz. Tube 24 22 0.65

RECTORSEAL® HI-TEMP

Silicone Caulk

PAGE 1
RECTORSEAL® HI-TEMP Silicone Caulk DESCRIPTION: RectorSeal® HI-TEMP 100% RTV silicone caulk is a one component sealant which cures to a strong durable resilient elastomer. It will adhere to glass, clean metal, most types of non-oily woods, vulcanized silicone rubber, silicone resins, natural and synthetic fibers, ceramic, paper, as well as many painted and plastic surfaces. Meets the following specifications: USDA for use in federally inspected meat and poultry plants. F.D.A. reg. #21 CFR 177.
PAGE 2
RECTORSEAL® HI-TEMP Silicone Caulk INSTRUCTIONS: READ ALL DIRECTIONS, MSDS AND WARNINGS ON LABEL BEFORE USING 1. 2. 3. 4. Clean and dry all surfaces. Completely remove all dirt, grease and soap. Cut nozzle at desired bead size, apply bead of silicone. Most paint will not adhere to silicone. Surface should be painted first, then seal. Silicone "skins over" and becomes tack-free in 15 minutes, cures in 1 hour. Allow 24 hours for full cure and strength.