Instructions / Assembly

Typical lineset* capacity 92mm 3
1
/2
”
W x 2
1
/2
”
D 122mm 4
1
/2
”
W x 3
1
/4
”
D
92mm w/Single 1
1
/8” Lineset
BTU - 60,000
Suction Line - 1
1
/8”OD
(Insulation) - 1/2”
Liquid Line - 1/2”OD
Drain Line- 3/4”PVC
122mm w/Dual 3/4” Lineset
BTU - 36,000
Suction Lines - 3/4”OD
(Insulation) - 1/2”
Liquid Lines - 3/8”OD
Drain Line- 3/4”PVC
92mm w/Dual 3/4” Lineset
BTU - 36,000
Suction Lines - 3/4”OD
(Insulation) - 3/8”
Liquid Lines - 3/8”OD
Drain Line- 3/4”PVC
92mm w/Single 3/4” Lineset
BTU - 42,000
Suction Line - 3/4”OD
(Insulation ) - 1/2”
Liquid Line - 3/8”OD
(Insulation ) - 1/2”
Drain Hose - 7/8” OD
122mm w/Single 1
1
/8” Lineset
BTU - 60,000
Suction Line - 1
1
/8” OD
(Insulation) - 1”
Liquid Line - 1/2”OD
Drain Line- 3/4”PVC
122mm w/Dual 3/4” Lineset
BTU - 42,000
Suction Lines - 3/4”OD
(Insulation ) - 1/2”
Liquid Lines - 3/8”OD
(Insulation ) - 1/2”
Drain Hose - 7/8” OD
(1) Determine the path which the line-
set will follow and strike a chalk line to
mark the surface material. Attach the
base only of all ttings rst (ducting
will be placed last), along the marked
path, using fasteners of sufcient
length (not provided). Predrill where
necessary. Duct must terminate
with a tting to prevent cover
from sliding out of position.
Installation instructions
(2) Once all tting bases are
secured to the siding, measure
and cut ducting to t as needed.
Remember to account for some
seasonal expansion and contrac-
tion. Install and fasten ducting
bases. Attach bases only to
structure through provided punch
outs using fasteners of sufcient
length (not provided).
(4) Run lineset, drainhose,
wiring etc. over the tting
and duct bases and secure
to duct clips using tie wraps
of sufcient size.
(3) Position and twist in
lineset duct clips evenly
spaced throughout installation.
Nylon cable ties (not included)
slip through lineset duct clips
and fasten around lineset.
(5) Snap straight duct top over
mating straight base pieces. Seat
tting tops over mating tting bases
and secure with provided stain-
less screws. Duct must terminate
with a tting to prevent cover from
sliding out of position. If duct is
painted, or run horizontally,
adhere cover to base with
pvc cement.
963080
* Lineset size may change on Seer Rating
RectorSeal® 2601 Spenwick Drive - Houston, TX 77055 ph: 713.263.8001 - 800.231.3345 fax: [phone]
www.rectorseal.com - Like Us on Facebook