Install Instructions

IMPORTANT NOTICE
Congratulations on your purchase of a revolutionary new tool. RectorSeal® appreciates
the opportunity to help you be more efficient on the job by simplifying the otherwise
difficult task of setting up for a wire pull. RectorSeal
® has gone through extensive efforts
to make sure your tool is made of the most durable materials and will serve you for
years to come. However, all tools have their limits and Wire Snagger
® is no exception.
Be sure to read and follow the instructions, including the continuous service load and
intermittent load rating listed on the back side of this page. Or you may incur injury,
shorten the tool’s life, and/or damage the tool and void the warranty.
INSTRUCTIONS FOR WIRE SNAGGER®
The Wire Snagger ® is intended for use by Professional Electricians only as a Wire Pulling Tool, to be operated within its
documented limits and for its intended purpose. Do not insert finger into tools.
1. Straighten out the first twelve (12) inches of wire from spool
of wire to be pulled.
2. Push cable in until it reaches the bottom of the cap, then pull
back on wire to make sure the wire is set.
3. Attach Wire Snagger
® assembly to pulling rope.
4. Adequately lubricate conduit system with wire pulling
lubricant.
Note: To avoid sand/dirt contamination in the tools, do not
apply wire pulling compound directly on the Wire Snagger
®
tools. Start application of the wire pulling compound 12” to
24” behind the last Wire Snagger
®
5. Pull cable according to standard industry practices.
6. After completing the pull, remove cable from tool by cutting
the cable two (2) inches below the end of the Wire
Snagger
® tool, unscrew the cap of the tool and push the
remaining cable through the Wire Snagger
® tool Body.
7. Thoroughly clean the Wire Snagger
® after each use
to remove the dirt and pulling
compound from around
properly may result in
WARNING: Do not insert finger into Wire Snagger® tools.
Wire Only
RECTORSEAL 2601 Spenwick Dr Houston, TX 77055, USA 713-263-8001 or 800-231-3345 www.rectorseal.com
H-10
Wire Only
RectorSeal® warrants Wire Snagger® against defects in materials and workmanship for a period of one year following the
date of purchase. RectorSeal
® will repair or replace any Wire Snagger® that fails during the warranty period due to a defect
in materials or workmanship, excluding misuse and normal wear and tear.
WARRANTY
US Patent Number 6,883,782; 7,128,306;
7,246,789; 7,478,794
THHN
THHN
Insert the
cable into the
Wire Snagger
®
body
Attach
Wire Snagger
®
to pulling rope
with clevis
After the pull, cut
the wire behind
the tool body and
unscrew the cap
Push the cut wire
through the other
end of the
tool body
the teeth. Failure to clean tool
improper engagement of the teeth.