Instructions / Assembly

Typical lineset* capacity LD-92 3
1
/2
”
W x 2
1
/2
”
D LD-122 4
1
/2
”
W x 3
1
/4
”
D
LD-92 w/Single 1
1
/8” Lineset
BTU - 60,000
Suction Line - 1
1
/8”OD
(Insulation) - 1/2”
Liquid Line - 1/2”OD
Drain Line- 3/4”PVC
LD-122 w/Dual 3/4” Lineset
BTU - 36,000
Suction Lines - 3/4”OD
(Insulation) - 1/2”
Liquid Lines - 3/8”OD
Drain Line- 3/4”PVC
LD-92 w/Dual 3/4” Lineset
BTU - 36,000
Suction Lines - 3/4”OD
(Insulation) - 3/8”
Liquid Lines - 3/8”OD
Drain Line- 3/4”PVC
LD-92 w/Single 3/4” Lineset
BTU - 42,000
Suction Line - 3/4”OD
(Insulation ) - 1/2”
Liquid Line - 3/8”OD
(Insulation ) - 1/2”
Drain Hose - 7/8” OD
LD-122 w/Single 1
1
/8” Lineset
BTU - 60,000
Suction Line - 1
1
/8” OD
(Insulation) - 1”
Liquid Line - 1/2”OD
Drain Line- 3/4”PVC
LD-122 w/Dual 3/4” Lineset
BTU - 42,000
Suction Lines - 3/4”OD
(Insulation ) - 1/2”
Liquid Lines - 3/8”OD
(Insulation ) - 1/2”
Drain Hose - 7/8” OD
(1) Determine the path which the line-
set will follow and strike a chalk line to
mark the surface material. Attach the
will be placed last), along the marked
length (not provided). Predrill where
necessary. Duct must terminate
from sliding out of position.
Installation instructions
(2) -
cured to the siding, measure and
Remember to account for some
seasonal expansion and contrac-
tion. Install and fasten LD Ducting
bases. Attach bases only to struc-
ture through provided punch outs
(not provided).
(4) Run lineset, drainhose,
and duct bases and secure
to duct clips using tie wraps
(3) Position and twist in
lineset duct clips (Model#
LDC) evenly spaced through-
out installation. Nylon cable
ties (not included) slip through
lineset duct clips and fasten
around lineset.
(5) Snap straight duct top over
mating straight base pieces. Seat
and secure with provided stainless
screws. Duct must terminate with a
out of position. If duct is to be
painted, or duct is a dark
color, adhere cover to base
with pvc cement.
ZLI080
* Lineset size may change on Seer Rating
c
®