Full Product Manual

Installation
Position the Satellite Speakers and Subwoofer in your selected location. Adjust them accordingly
where they would appear to give you the best sound coverage.
We recommend that you first dig a hole for the Subwoofer. It can be installed vertically or
horizontally. Once chosen, dig a hole a size that would accommodate it. If installed horizontally,
the hole would need to be approximately 15” Wide x 30” Long x 17-19” Deep. This will leave
approximately 6-8” of the Subwoofer port tube and cap above the ground after the installation.
We suggest that you add 1-2” of gravel at the bottom of the hole to facilitate drainage around the
base of unit. If you do add gravel, dig the hole 1-2” deeper to accommodate the layer of gravel.
Dig a 5” deep trench where you plan to lay out the wire. It’s a good idea to use the same 5” trench
for all of the wire.
Wiring
We recommend that you use only multi-strand direct
burial wire. The gauge of the wire will depend on the
length of the run. This is noted on Page 3 of this manual.
The positive and negative wires are noted by red (+) for
Positive and black (-) for Negative.
Your Audio Source, Satellite Speakers & Subwoofer all use
red for Positive & black for Negative.
It is very important that the same wire that is attached to the Positive connector of the Audio
Source is attached to the Positive connector of the speakers.
Prior to digging, we
recommend that you
call 811 or 888-344-7233
in the United States.
A person will come
out and mark all the
underground cables &
gas line if applicable.