Owner Manual

OPERATION
This section will explain the function of each convenient control.
NOTE
The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused
by initial heating of internal heater parts and will not occur agai
 Control Panel Operation
A. Buttons and Indicators
There are four buttons on the remote control
with the same label perform the same function, the back of it is manual switch near the
<ON/OFF> button is power switch of the heater;
<DIMMER> button is used to adjust the brightness of simulated flame and logs;
<LOW> button turns the fireplace insert on and switches it to low
is already working at low
<HIGH> button turns the fireplace insert on and switches it to high
already working at high-power status, to push this button will turn the fireplac
There are four indicators on the control panel:
is the power indicator, it lights up when the
turned off;
indicates the status of the simulated flame and logs.
indicates the heater is w
indicates the heater is working in high
The red window on the control panel of
This section will explain the function of each convenient control.
The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused
by initial heating of internal heater parts and will not occur again.
Control Panel Operation
buttons on the remote control, and four on the control panel of the heater
with the same label perform the same function, the back of it is manual switch near the po
<ON/OFF> button is power switch of the heater;
<DIMMER> button is used to adjust the brightness of simulated flame and logs;
<LOW> button turns the fireplace insert on and switches it to low-power status.
ng at low-power status, to push this button will turn the fireplace off.
<HIGH> button turns the fireplace insert on and switches it to high-power status.
power status, to push this button will turn the fireplac
There are four indicators on the control panel:
is the power indicator, it lights up when the heater is working, and turned out when the
indicates the status of the simulated flame and logs.
indicates the heater is working in low-power status;
indicates the heater is working in high-power status.
The red window on the control panel of heater is the eye of receiver, please do not cover
The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused
heater, each pair of buttons
power cord:
power status. If the fireplace insert
power status, to push this button will turn the fireplace off.
power status. If the fireplace is
power status, to push this button will turn the fireplace off;
is working, and turned out when the heater is
do not cover.