Owner Manual

B. Operation
On the first use of remote control, install the battery first: open the battery box by sliding its cover along
the arrow, install one (1) coin cell battery according to the marks in the box, and slide the cover to its
original position. If no battery installed or the battery is not working, the remote control will be unusable.
To use the remote control effectively, point it to the electric fireplace and keep a distance of 1-5 meters.
There are four buttons marked the same as buttons on the remote control, each pair of them perform the
same function, choose as you favour.
1. On/Off Switch. Press on/off switch to turn fire on. The indicator lamp will brighten up in the
control panel. Press the <ON/OFF> button again; the fireplace insert will be powered off.
2. Flame Effect Dimmer. Adjust the brightness of simulated flame and logs. When the fireplace insert
is powered on, flame is turned on automatically. Press <DIMMER> button to adjust the brightness,
the lamp will be flashing. During the dimming cycle the fire will slowly dim then brighten allowing
user to choose suitable level. Press a second time to stop cycle when the desired brightness level is
obtained.
3. Heater Low Heat (750 W). Press <LOW> button once to switch the fireplace insert to low-power
status. The indicator lamp will brighten up. Press again the <LOW> button to turn it off.
4. Heater High Heat (1500 W). Press <HIGH> button once to switch the fireplace insert to high-power
status. The indicator lamp will brighten up. Press again the <HIGH> button will turn it off.
NOTE: Before the heater emits heat or after it stops producing heat, the hot air outlet may output air
for 10 seconds. This is designed to protect the circuit.
5. Switch off the heater when you leave it for a long time.
6. Remove the lithium battery from the appliance before it is scrapped.
7. The lithium battery needs to be disposed of safely.
8. Roll up the power cord in the supports when the fireplace is not in use. If you select to store your
heater fully assembled, be sure to cover it, to protect it from accumulating dust.
9. Temperature Limiting control will automatically turn the unit off if it reaches a certain temperature.
Unplug the unit. When the temperature falls, the thermostat will be restored. Connect the plug to
power and heater will work.