Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
#1 Prepare 8 bolts assembly by inserting lock washer (#B), then flat washer (#C) onto bolts (#A). Align legs (#2) to the holes of the apron (#3) and middle shelf (#4). Secure with bolts (#A). #3 #A x 8pcs #B x 8pcs #C x 8pcs #C #B #4 #A #2 #D #2 Prepare 4 bolts assembly by inserting lock washer (#B), then flat washer (#C) onto bolts (#A). Align connect board (#5) to the holes on the top of the legs (#2). Secure with bolts (#A).
Prepare 16 screws assembly by inserting flat washer (#C) onto screws (#E). Insert wood dowels (#F) to the center holes of the connect board (#5). Align connect board to the holes of the table top (#1). Secure with screws (#E).
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
#H #1 #B #B x 2pcs #C x 2pcs #D x 2pcs Prepare 2 bolts assembly by inserting lock washer (#C), then flat washer (#D) onto bolts (#B). Align chair seat (#2) to the holes of the chair back (#1). Secure the middle two holes with bolts (#B). #C #D #2 #1 Prepare 4 bolts assembly by inserting lock washer (#C), then flat washer (#D) onto bolts (#A). Secure corner holes of chair seat (#2) with bolts (#A).
1) Align the front legs (#3L/R) to the holes of the chair seat (#2). Insert flat washer (#D), then lock washer (#C) onto threaded bolts of legs (#3L/R). Secure with hex nut (#E), but do not tighten. #3 2) Insert front stretcher (#4) and left/right stretchers (#5) to the legs as shown in the picture. Tighten hex nut (#E) of the front legs. #C x 4pcs #D x 4pcs #E x 4pcs #3L #2 #D #3R #C #4 #E #5L #5R #G Secure stretchers (#4,5) with screws (#F).
