Assembly Instruction

(2)A19MediumBaseBulbs75WMaximum
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
LightSource:
Estimated Assembly Time:
Preparation:
ToolsRequired:None.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
Finial
x1
Shade
x1
Bulb (not
included)
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
Flat Washer
x1
Big Knurled
Nut x 1
Small
Knurled Nut
x1
6.25” SQ.
7.25”
16” SQ.
Base
x1
FINISH: VALIANT BRONZE
Cord
24.75”
Check Ring
x1
4.25”L
Spacer Tube
x1
4.75”L Nipple
with Hex Nut
x1
A. Thread the hex nut end of the
Nipple with Hex Nut into the
hex coupling on the top
center of the Base. By using
the pliers, thread the hex nut
against the hex coupling and
hand tighten until snug.
B. Place the Spacer Tube and
the Check Ring over the top
end of the Nipple and secure
with the Small Knurled Nut.
Hand tighten until snug.
C. Thread the Big Knurled Nut
onto the top end of the Nipple
and adjust it to proper
location for rest components.
Place the Flat Washer and
the Shade over the top end of
the Nipple and make sure
Shade is parallel with Base.
Secure with the Finial and
hand tighten until snug.
D. Insert bulbs onto sockets and
screw snugly into place.
Your fixture is now assembled
and ready to use. Enjoy!
Incorrect
base/ socket/
shade Orientation
Correct
base/ socket/
shade Orientation
Assembly Instruction Sheet
1of1
Thank you for purchasing a product.